Installing the Magic Film®
2 Types of installations, self-adhesive or standard
Start by measuring the exact dimensions of the location where you want to install the Magic Film®.
Keep a margin of approximately 2 / 3 mm from the edges of the frame or void. (Warning, if there is a metal frame, please take a margin of at least 5mm on each side so as not to disturb the electric field of the film)
Contact us to order by indicating the color, the dimensions and the location of the connectors. (The connectors can be located on the length or the width and measures about 8 mm, which be taken into account during the measurements)
Laying the Magic Film® in a self-adhesive version
You have just received your Magic Film®, unwrapped it carefully, and laid it flat in a place to protect it from any damage.
​
​
The Magic film® is protected by 2 transparent films, one for the protection of the marouflage,
and the other for the protection of the self-adhesive surface.
Clean the installation surface with the appropriate products and clean the protection
on the self-adhesive side to eliminate the maximum of dust.
​
Remove the protective film from the adhesive side about 5 to 10 cm, starting from the top of the film, so that it can be adjusted to the best of the application surface, then apply the Magic Film® to the surface.
​
Rub this first strip so that the Magic Film® adheres to the surface, then gradually remove the protection while passing the squeegee horizontally in strips of about 10 cm.
​
Once the Magic Film® is completely installed, all that remains is to connect the transformer to the film,
then connect the transformer to your power outlet.
A detailed installation guide will be provided with your order
Laying of Magic Film® in standard version
You have just received your Magic Film®, unwrapped it carefully, and laid it flat in a place protected from any damage.
Magic film® is protected by 2 transparent films.
Clean the installation surface using the appropriate products and then clean the protection on the side that will be in contact with the laying surface to eliminate the maximum amount of dust.
Apply our double-sided clear tape on each side of the installation surface.
Completely remove the rear protective film, then apply the Magic Film® on the adhesive tape, starting at the top so that it can be adjusted to the best of the installation surface.
Once the Magic Film® is completely installed, all that remains is to connect the transformer to the film, then connect the transformer to your power outlet.
​
A detailed installation guide will be provided with your order
Copyright © 2016 Seedertech GR seedertech.com All Rights reserved!